1
20.7 Legacy Series / Fine tuning BGP
« on: November 01, 2020, 05:47:44 pm »
Hi guys,
I need some help fine-tuning my FRR BGP Setup.
In particular, setting up "set" parameters on the Route Map.
I need to set a weight or local-preference on the route map via the "set" option as shown on the "Edit route Maps" screen.
However, I've tried adding the following combinations there, but it just doesn't show up in the actual config when issuing sh run from vtysh.
I tried:
local-preference 300
"local-preference 300"
set local-preference 300
"set local-preference 300"
I tried the same for weight, with the same results, they just don't show up in the actual config.
I can add them using "vtshy" and conf term. But I would rather have it done by the gui
Any recommendations on the correct syntax for the "Set" field is more than welcome.
Cheers
Niels
I need some help fine-tuning my FRR BGP Setup.
In particular, setting up "set" parameters on the Route Map.
I need to set a weight or local-preference on the route map via the "set" option as shown on the "Edit route Maps" screen.
However, I've tried adding the following combinations there, but it just doesn't show up in the actual config when issuing sh run from vtysh.
I tried:
local-preference 300
"local-preference 300"
set local-preference 300
"set local-preference 300"
I tried the same for weight, with the same results, they just don't show up in the actual config.
I can add them using "vtshy" and conf term. But I would rather have it done by the gui
Any recommendations on the correct syntax for the "Set" field is more than welcome.
Cheers
Niels