1
Hardware and Performance / Re: DEC740 Reset or Serial Install
« on: April 18, 2023, 03:08:35 pm »
After a reboot of the notebook and attaching the DEC740 to a different USB port I am able to see /dev/ttyUSB0
However, I am not able to enter much. It does seem to connect to it though, since once it mentioned something like amd/freeBSD and another time it asked for a login but I was not able to enter anything. If I press ctrl-a for a while it prints ^A, but ctrl-a-z does not show any help regarding special keys.
As terminal software, I'm using the normal GNOME one and I have also tried macOS' terminal when connecting via ssh.
I am also able to open both minicom and screen at the same time, whereas an additional minicom says the device is locked.
I rebooted the device again and this time I was able to access the firewall. So, now I can configure it properly again and set it up. Thank you very much for your help
As terminal software, I'm using the normal GNOME one and I have also tried macOS' terminal when connecting via ssh.
I am also able to open both minicom and screen at the same time, whereas an additional minicom says the device is locked.
I rebooted the device again and this time I was able to access the firewall. So, now I can configure it properly again and set it up. Thank you very much for your help