Topics

My goal: is to have 3-5 VLANs with some access to other VLANs and some blocked from the internet. My layout
OPNsense
WAN
LAN
-VLAN1(192.168.10.1) -VLAN 2(192.168.20.1) parent interface set to LAN.

Juniper Switch EX4200 48 port
Port 0 -> LAN OPNsense
Port 1 -> VLAN 1
Port 24 -> VLAN 2
Port 2-23/25-47-> Default

attempt1:
My PC is plugged into Port 1. I should have VLAN1. I'm unable to connect to both my switch and OPNsense. When I check my IP with ifconfig I see my IP is still from from default LAN(192.168.0.3). Have to move PC to Switch-Port2 to gain access to switch. I am able to connect OPNsense VLAN1 gateway(192.168.10.1)

attempt 2:
I've read that you have to setup a Trunk port between the switch and OPNsense so I set Switch-Port0 to trunk mode. Added VLAN1 and VLAN2 as members to Trunk Switch-Port0. PC is plugged into Port 1. Unable to connect OPNsense and Switch. When I move my PC to Switch-Port2(Default LAN) I'm able to connect back to the switch but OPNsense unable to connect to VLAN1 gateway. I have to turn off trunk mode on Switch-Port0 to regain access to OPNsense.