OPNsense Forum
English Forums => Virtual private networks => Topic started by: vaisatimm on October 11, 2021, 05:10:09 pm
-
Hello, everyone.
I'm new in this forum, so I'm sorry if this is not the right section to post this issue.
The issue is:
After deploying with Terraform the OPNSense Master and Backup, I try to importing the config.xml via web browser to put all the configurations that I have on other enviroments, but I see that after applying it, the nets (LAN and WAN) result inverted. I am quite sure that the problem is in the config.xml I upload.
The question is: where could be the mistake in this xml? I am asking this since the xml is about 1000 lines and I could not find the specific mistake that makes the nets inverted.
Thank you very much.
Regards.
-
I think its at
<opnsense>
<interfaces>
<wan/lan>
<if>